Multi Port PRI Configuration - Revision history

Mike Lunn at 15:32, 20 January 2016

2016-01-20T15:32:31Z

Mike Lunn at 17:05, 12 March 2014

2014-03-12T17:05:06Z

John Wolfe: Created page with "File: This is a screen capture for a two card 3 port configuration. In this configuration there is a two port T205 Digium Card and a single port T110 Card. The Dual por..."

2013-06-27T15:32:58Z

Created page with "[[File:]] This is a screen capture for a two card 3 port configuration. In this configuration there is a two port T205 Digium Card and a single port T110 Card. The Dual por..."

New page

[[File:]]

This is a screen capture for a two card 3 port configuration. In this configuration there is a two port T205 Digium Card and a single port T110 Card. The Dual port card is thei first card and the single port card is configured as card 2. Note that the D channel is the same on all three. This is due to the 2 ports of the dual port using the common D Channel. And the single port card is also using 24 but this is the D channel within its circuit.

← Older revision		Revision as of 15:32, 20 January 2016
Line 4:		Line 4:
	*Multiple Port cards increment the start and end channel. So you'd make a channel group for 1-23, then a channel group for 25-47, and so on.		*Multiple Port cards increment the start and end channel. So you'd make a channel group for 1-23, then a channel group for 25-47, and so on.
	*Channel numbering starts over when you have a second card. So you'd start over with a channel group for 1-23 for the second card.		*Channel numbering starts over when you have a second card. So you'd start over with a channel group for 1-23 for the second card.
		+	*Timing increments as you go along on the same card. Span 1 would be timing 1, span 2 would be timing 2, etc.

@@ Line 1: / Line 1: @@
-[[File:]]
+When configuring Mutliple PRI Cards or one card with Multiple ports, its important to know the following.
+*D Channel is Always 24
+*Multiple Port cards increment the start and end channel.  So you'd make a channel group for 1-23, then a channel group for 25-47, and so on.
-This is a screen capture for a two card 3 port configuration. In this configuration there is a two port T205 Digium Card and a single port T110 Card. The Dual port card is thei first card and the single port card is configured as card 2. Note that the D channel is the same on all three. This is due to the 2 ports of the dual port using the common D Channel. And the single port card is also using 24 but this is the D channel within its circuit.
+*Channel numbering starts over when you have a second card.  So you'd start over with a channel group for 1-23 for the second card.