Barix Instreamer

The Barix Instreamer is a 3rd party device that allows you to connect a stereo RCA source on one side, and the network on the other side. With this setup, you can set the Barix as your source for the PBX to stream Music On Hold, or you can use it as a Multicast source for the IPitomy SIP Speaker to stream music overhead. You can purchase the Barix Instreamer from the following link: http://shop.lineq.com/Instreamer_c_15.html

First Time Setup

These basic instructions should be followed whether you are using the Barix for streaming MOH or for playing music overhead.

1. Unbox the Barix and connect your network to the LAN port on the back of the device.
2. Connect your source RCA cables to the correct left/right inputs on the back of the device.
3. Connect headphones to the jack on the front of the device. This will be used to determine the IP address of the device on power up. (By default the device pulls DHCP from the network.
4. While wearing the headphones, connect the power to the back of the device. Note the IP address as this will be used to access the device.
5. From a web browser, enter the IP address of the device
6. Navigate to Configuration=>Advanced=>Network
7. Give the device an unused static IP that is not in the network DHCP range, and set a valid subnet mask, gateway, and DNS
8. Click Apply and allow the device to reboot. Note the static IP that was set as you'll use that to access it moving forward
9. Navigate to Update and follow the instructions to upgrade to the most current firmware version

Streaming Music on Hold

For this setup, you'll need to create a Streaming MOH Playlist. You'll need to set the URL to the static IP address you set for the Barix.

1. Log into the Barix device via the static IP that was set on initial setup.
2. Navigate to Configuration=>Advanced=>Audio and set as follows
3. Click Apply
4. Navigate to Configuration=>Advanced=>Streaming and set as follows
5. Click Apply