Difference between revisions of "Cisco SPA112 FXS Gateway"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| − | By default, the Cisco SPA112 will pull DHCP from your network | + | By default, the Cisco SPA112 will pull DHCP from your network. You can discern the IP address via Autodiscovery if you switch the Filter to None, or by viewing the DHCP leases in the router. If you have an SPA122, connect your PC to the LAN port and access via the IP 192.168.15.1 to program, then when done, connect the WAN port of the device to the network. |
==Configuration== | ==Configuration== | ||
Revision as of 15:43, 26 June 2013
By default, the Cisco SPA112 will pull DHCP from your network. You can discern the IP address via Autodiscovery if you switch the Filter to None, or by viewing the DHCP leases in the router. If you have an SPA122, connect your PC to the LAN port and access via the IP 192.168.15.1 to program, then when done, connect the WAN port of the device to the network.
Configuration
- Log into the IP address of the Gateway (user: admin | pass: admin)
- Navigate to Quick Setup
- Line 1 and Line 2 will be where you configure your SIP extensions from the PBX as follows:
- Proxy: IP address of the PBX
- Display Name: Extension Number
- User ID: Extension Number
- Password: SIP Password for the extension
- Click Submit
Once this is completed, the extension should be registered and functional.
NOTE If you are configuring multiple extensions to the Gateway, be sure to set them in the PBX to UserType = Friend.