IP PBX Manual Reporting Diagnostics

From IPitomy Wiki
Revision as of 13:42, 23 May 2013 by Nichole (Talk | contribs)
Jump to: navigation, search



Logo on white background (small).gif
support@ipitomy.com | 941.306.2200 (Opt 2 for Support)
You are viewing the IPitomy IP PBX Manual, Table of Contents.


Diagnostics

This section, when configured under PBX Setup->Services, displays a message log of actions in the PBX. Typically this page will be referenced by Tech Support to pinpoint where troubleshooting for a specific problem should begin.

Systemdiagnosticspage.png

View System Diagnostics

STEPS:

  1. Click the Reporting->Diagnostics linkon the Admin Page.
  2. The System Diagnostics page appears displaying the messages that have been processed and their status.
  3. The type of message that is displayed on this page is set in the Logging Level section of the Systems page.

Common Error Messages and their Meanings

Error Message
Problem
rtp.c: Comfort noise support incomplete in Asterisk (RFC 3389). Please turn off on client if possible. Client IP XXX.XXX.XXX.XXX
This may or may not be an issue.  If you have a local client that has comfort noise support on, turn it off.  If it is a Provider, you may want to set RTP-Keep Alive.  Note if you have no music on hold and you place a client like this on hold, they will be disconnected if you have set RTP Timeout or RTP Timeout on hold, once this timer has elapsed.
NOTICE chan_sip.c: Disconnecting call 'SIP/XXX-XXXXXXX' for lack of RTP activity in 11 seconds
If you have RTP Timeout set, (which is a good thing).  Then a call to SIP/<EXTENSION# or PROVIDER NAME> was terminated because voice traffic that was expected did not transmit for 11 seconds.
Call from to extension 'XXXX' rejected because extension not found

Someone tried to make a guest call to your system.  If Guest calls are allowed under PBXSetup->SIP, then they can be made to 's' by or any dids only.  If you notice a lot of these and that your system performance is degrading, it is recommended that you do a packet capture to determine the offending IP address and then block it with an ACL entry to prevent system performance from being affected.

Note if from has an extension in it then it indicates that a number that is not supported by the dialplan was dialed.  Like 1 for instance.

WARNING[19775] app_queue.c: Unable to join queue 'rg_2'
Due to any number of configuration reasons, the call was not able to join the group. It could be the group is empty, it could be the group has a limit to how many calls it can process at one time.
ERROR[18636] utils.c: write() returned error: Broken pipe
This means that an audio file was playing (MOH, Prompt, VM) and the call was ended (user hung up, call dropped, etc).


WARNING app_dial.c: Unable to create channel of type 'SIP' (cause 20 - Unknown)
This occurs when someone tries to dial a SIP device that is supposed to be there but for some reason it cannot be contacted.  This could be an extension that was registered but is not responding because it has lost power, it could be a SIP provider that cannot be reached.  There are a lot of issues that can cause this message.
Personal tools
Namespaces
Variants
Actions
Navigation
Toolbox